Bently Nevada BA42608-12-01 Proximity Probe Housing

Product Introduction

The Bently Nevada BA42608-12-01 is a probe housing assembly (Proximity Probe Housing), engineered for continuous protection of rotating machinery. TenBN supplies this genuine Bently Nevada component with full documentation and ready stock for plants running condition monitoring programs on critical equipment.

Technical Parameters

• Model: BA42608-12-01
• Product Type: Proximity Probe Housing
• Mounting thread and cap Option: 12 =3/4-in 14 NPT with tall cap
• Cable exit fitting Option: 01=1/2-in NPT plug

Parameter Analysis

The ordering string of the BA42608-12-01 encodes its physical and electrical configuration, so every digit should be checked against the machine drawing before substitution. The mounting thread and cap Option specifies 12 =3/4-in 14 NPT with tall cap. The cable exit fitting Option specifies 01=1/2-in NPT plug. The unit is rated for operation from -29°C to +121°C (-20 °F to +250°F).

The housing assembly seals the probe penetration against wash-down and dust while allowing standard probe maintenance, combining mechanical protection with the electrical performance of the enclosed probe.

Application Scenarios

This housing assembly protects the proximity probe where it passes through the machine casing on turbines, compressors, and pumps. It is well suited to wash-down areas, outdoor installations, and hazardous locations where the probe needs mechanical and environmental protection.

Installation Guide

Confirm every option digit against the machine drawing, mount the housing through its threaded connection, tighten the retaining nut to the documented torque, and keep the sleeve O-rings seated to preserve the environmental seal. Set the probe gap after assembly and verify before start-up.

Compatibility

This component belongs to the Bently Nevada condition monitoring portfolio and is engineered to work with the associated probes, extension cables, Proximitors, and monitoring hardware of the same system. Bently Nevada components sharing the same part number are fully interchangeable, so a stocked spare can be fitted without re-engineering the measurement loop. TenBN can supply the complete chain under consistent part numbers.

Maintenance Advice

Inspect the housing cover, screws, and O-rings at each maintenance opportunity, and confirm the retaining nut torque has not relaxed in service. Keep the unit within its -29°C to +121°C (-20 °F to +250°F) operating envelope in service and storage.

Procurement Advice

This unit is supplied new & original in factory packing with 12 months factory warranty. Confirm the complete part number against your machine’s bill of materials before ordering, since each option digit changes the mechanical or electrical fit. TenBN stocks genuine Bently Nevada components and provides the official service documentation for this model. For inventory, pricing, and lead time on the BA42608-12-01, contact [email protected].

Frequently Asked Questions

What is the operating temperature range?

The unit is rated from -29°C to +121°C (-20 °F to +250°F), covering the temperature extremes typical of turbomachinery installations.

Can this spare be interchanged with existing components?

Bently Nevada components sharing the same part number are fully interchangeable, so this spare can replace an existing unit without recalibrating the loop when the complete part number matches.

How do I confirm the right part number?

Check every option digit against the machine bill of materials, then contact [email protected] with the full string; the TenBN team will confirm fit, stock, and documentation.