Bently Nevada 9200-02-01-10-00 Two-Wire Velocity Seismoprobe Transducer

Product Introduction

TenBN offers the genuine Bently Nevada 9200-02-01-10-00, a proximity probe (Two-Wire Velocity Seismoprobe Transducer) built for the demands of continuous machinery protection. The component is held in inventory for fast shipment to plants operating turbines, compressors, pumps, and other rotating assets.

Technical Parameters

• Model: 9200-02-01-10-00
• Product Type: Two-Wire Velocity Seismoprobe Transducer
• Product Series: 9200
• Transducer mounting angle/minimum operating frequency Option: 02 45 ±2.5, 4.5 Hz (270 cpm)
• Connector Option: 01 Top Mount (no cable)
• Mounting base Option: 10 Circular; M10X1 stud
• Agency approval Option: 00 No approvals required

Parameter Analysis

Each option block in the 9200-02-01-10-00 part number defines one element of the hardware configuration, from mechanical dimensions to connector style and approval suffix. The transducer mounting angle/minimum operating frequency Option specifies 02 45 ±2.5, 4.5 Hz (270 cpm). The connector Option specifies 01 Top Mount (no cable). The mounting base Option specifies 10 Circular; M10X1 stud. The unit is rated for operation from -29°C to +121°C (-20°F to +250°F). Compliance documentation covers no approvals required.

Probe performance is specified together with the matching extension cable and Proximitor, so replacing the complete loop under consistent part numbers preserves the calibrated scale factor and linearity of the measurement chain.

Application Scenarios

This probe is installed on steam and gas turbines, compressors, pumps, motors, and fans to measure radial and axial shaft vibration, position, and speed. It feeds the associated monitoring rack, giving operators the early warning needed to plan maintenance before a developing fault becomes unplanned downtime.

Installation Guide

Thread the probe into its tapped hole, respect the thread engagement limits of the case, and mate the connector to the matching extension cable. Set the initial gap according to the electrical requirements of the associated Proximitor and verify the gap voltage against system documentation before returning the machine to service.

Compatibility

This component belongs to the Bently Nevada condition monitoring portfolio and is engineered to work with the associated probes, extension cables, Proximitors, and monitoring hardware of the same system. Bently Nevada components sharing the same part number are fully interchangeable, so a stocked spare can be fitted without re-engineering the measurement loop. TenBN can supply the complete chain under consistent part numbers.

Maintenance Advice

Inspect the probe tip, threads, and cable jacket at each outage for wear or damage, and confirm connector seating and torque have not relaxed in service. Keep the unit within its -29°C to +121°C (-20°F to +250°F) operating envelope in service and storage.

Procurement Advice

This unit is supplied new & original in factory packing with 12 months factory warranty. Confirm the complete part number against your machine’s bill of materials before ordering, since each option digit changes the mechanical or electrical fit. TenBN stocks genuine Bently Nevada components and provides the official service documentation for this model. For inventory, pricing, and lead time on the 9200-02-01-10-00, contact [email protected].

Frequently Asked Questions

What is the operating temperature range?

The unit is rated from -29°C to +121°C (-20°F to +250°F), covering the temperature extremes typical of turbomachinery installations.

What approvals or certifications does it carry?

Compliance documentation covers no approvals required. Confirm the approval suffix on your part number before ordering for hazardous-area use.

What connector or interface does it use?

It uses top Mount (no cable), matching the standard Bently Nevada measurement chain.

Can this spare be interchanged with existing components?

Bently Nevada components sharing the same part number are fully interchangeable, so this spare can replace an existing unit without recalibrating the loop when the complete part number matches.