Bently Nevada 3500/53-03-00 Proximity Probe

Product Introduction

TenBN offers the genuine Bently Nevada 3500/53-03-00, a proximity probe built for the demands of continuous machinery protection. The component is held in inventory for fast shipment to plants operating turbines, compressors, pumps, and other rotating assets.

Technical Parameters

• Model: 3500/53-03-00
• Product Type: Proximity Probe
• Product Series: 3500
• Origin: U.S.A Ordering Information
• Input Impedance: 20 k Ω
• Power Consumption: 8.0 watts, typical
• OK LED: Indicates when the 3500/53 Module is operating properly
• TX/XR LED: Indicates when the 3500/53 Module is communicating with other modules in the 3500 rack
• Bypass LED: Indicates when the 3500/53 Module is in Bypass Mode
• Test Mode LED: Indicates when the 3500/53 is in Test Mode
• Alarm LEDs: Indicates that an alarm condition has occurred with the associated relay
• Output Impedance: 550 Ω
• Transducer Power Supply: -24 Vdc, 40 mA maximum
• Recorder: +4 to +20 mA. Values are proportional to module full-scale range (rpm). Module operation is unaffected by short circuits on recorder output

Parameter Analysis

Each option block in the 3500/53-03-00 part number defines one element of the hardware configuration, from mechanical dimensions to connector style and approval suffix. The unit is rated for operation from -30 °C to +65 °C (-22 °F to +149 °F).

Probe performance is specified together with the matching extension cable and Proximitor, so replacing the complete loop under consistent part numbers preserves the calibrated scale factor and linearity of the measurement chain.

Application Scenarios

This probe is installed on steam and gas turbines, compressors, pumps, motors, and fans to measure radial and axial shaft vibration, position, and speed. It feeds the associated monitoring rack, giving operators the early warning needed to plan maintenance before a developing fault becomes unplanned downtime.

Installation Guide

Thread the probe into its tapped hole, respect the thread engagement limits of the case, and mate the connector to the matching extension cable. Set the initial gap according to the electrical requirements of the associated Proximitor and verify the gap voltage against system documentation before returning the machine to service.

Compatibility

This component belongs to the 3500 series monitoring rack and is engineered to work with the associated probes, extension cables, Proximitors, and monitoring hardware of the same system. Bently Nevada components sharing the same part number are fully interchangeable, so a stocked spare can be fitted without re-engineering the measurement loop. TenBN can supply the complete chain under consistent part numbers.

Maintenance Advice

Inspect the probe tip, threads, and cable jacket at each outage for wear or damage, and confirm connector seating and torque have not relaxed in service. Keep the unit within its -30 °C to +65 °C (-22 °F to +149 °F) operating envelope in service and storage.

Procurement Advice

Confirm the complete part number against your machine’s bill of materials before ordering, since each option digit changes the mechanical or electrical fit. TenBN stocks genuine Bently Nevada components and provides the official service documentation for this model. For inventory, pricing, and lead time on the 3500/53-03-00, contact [email protected].

Frequently Asked Questions

What is the operating temperature range?

The unit is rated from -30 °C to +65 °C (-22 °F to +149 °F), covering the temperature extremes typical of turbomachinery installations.

Can this spare be interchanged with existing components?

Bently Nevada components sharing the same part number are fully interchangeable, so this spare can replace an existing unit without recalibrating the loop when the complete part number matches.

How do I confirm the right part number?

Check every option digit against the machine bill of materials, then contact [email protected] with the full string; the TenBN team will confirm fit, stock, and documentation.