Bently Nevada 21022-30-10-017-03 Dual Axial Probe Housing Assembly

Product Introduction

TenBN offers the genuine Bently Nevada 21022-30-10-017-03, a probe housing assembly (Dual Axial Probe Housing Assembly) built for the demands of continuous machinery protection. The component is held in inventory for fast shipment to plants operating turbines, compressors, pumps, and other rotating assets.

Technical Parameters

• Model: 21022-30-10-017-03
• Product Type: Dual Axial Probe Housing Assembly
• Product Series: 21022
• Origin: U.S.A Probe Option
• Probe Option: with Connector: 30 = 3300 XL 11 mm probe, Multiple approvals
• Probe cable length Option: 10 = 1.0 metre (39 in)
• Probe penetration Option: ： 017= 1.7 in
• Fittings Option: are supplied as a kit and are not installed when the housing is shipped

Parameter Analysis

Each option block in the 21022-30-10-017-03 part number defines one element of the hardware configuration, from mechanical dimensions to connector style and approval suffix. The probe Option specifies with Connector: 30 = 3300 XL 11 mm probe, Multiple approvals. The probe cable length Option specifies 10 = 1.0 metre (39 in). The probe penetration Option specifies ： 017= 1.7 in.

The housing assembly seals the probe penetration against wash-down and dust while allowing standard probe maintenance, combining mechanical protection with the electrical performance of the enclosed probe.

Application Scenarios

This housing assembly protects the proximity probe where it passes through the machine casing on turbines, compressors, and pumps. It is well suited to wash-down areas, outdoor installations, and hazardous locations where the probe needs mechanical and environmental protection.

Installation Guide

Confirm every option digit against the machine drawing, mount the housing through its threaded connection, tighten the retaining nut to the documented torque, and keep the sleeve O-rings seated to preserve the environmental seal. Set the probe gap after assembly and verify before start-up.

Compatibility

This component belongs to the 3300 XL 11 mm proximity system and is engineered to work with the associated probes, extension cables, Proximitors, and monitoring hardware of the same system. Bently Nevada components sharing the same part number are fully interchangeable, so a stocked spare can be fitted without re-engineering the measurement loop. TenBN can supply the complete chain under consistent part numbers.

Maintenance Advice

Inspect the housing cover, screws, and O-rings at each maintenance opportunity, and confirm the retaining nut torque has not relaxed in service.

Procurement Advice

Confirm the complete part number against your machine’s bill of materials before ordering, since each option digit changes the mechanical or electrical fit. TenBN stocks genuine Bently Nevada components and provides the official service documentation for this model. For inventory, pricing, and lead time on the 21022-30-10-017-03, contact [email protected].

Frequently Asked Questions

What connector or interface does it use?

It uses are supplied as a kit and are not installed when the housing is shipped, matching the standard Bently Nevada measurement chain.

Can this spare be interchanged with existing components?

Bently Nevada components sharing the same part number are fully interchangeable, so this spare can replace an existing unit without recalibrating the loop when the complete part number matches.

How do I confirm the right part number?

Check every option digit against the machine bill of materials, then contact [email protected] with the full string; the TenBN team will confirm fit, stock, and documentation.