Bently Nevada 330104-04-10-05-01-CN 3300 XL 8 mm Proximity Probes

Product Introduction

The Bently Nevada 330104-04-10-05-01-CN is an extension cable (3300 XL 8 mm Proximity Probes), engineered for continuous protection of rotating machinery. TenBN supplies this genuine Bently Nevada component with full documentation and ready stock for plants running condition monitoring programs on critical equipment.

Technical Parameters

• Model: 330104-04-10-05-01-CN
• Product Type: 3300 XL 8 mm Proximity Probes
• Product Series: 330102 / 330103 / 104
• Origin: U.S.A
• Unthreaded length Option: 04= 40 mm
• Overall case length Option: 10=100mm
• Total length Option: 05 0.5 meter (1.6 feet)
• Connector and cable-type Option: 01
• Agency approval Option: CN Country Specific
• Probe Tip Material: Polyphenylene sulfide (PPS)
• Probe Case Material: AISI 303 or 304 stainless steel (SST)
• Probe Pressure: 3300 XL 8 mm probes are designed to seal differential pressure between the probe tip and case. The probe sealing material consists of a Viton® O-ring

Parameter Analysis

The ordering string of the 330104-04-10-05-01-CN encodes its physical and electrical configuration, so every digit should be checked against the machine drawing before substitution. The unthreaded length Option specifies 04= 40 mm. The overall case length Option specifies 10=100mm. The total length Option specifies 05 0.5 meter (1.6 feet). Compliance documentation covers country Specific.

Because cable, probe, and Proximitor are calibrated as a system, keeping the same part numbers across the loop preserves scale factor accuracy and simplifies replacement during outages.

Application Scenarios

Used wherever the proximity measurement loop must bridge the distance between probe and Proximitor, this cable suits junction-box and electronics-room installations on turbomachinery trains.

Installation Guide

Plan the run so that probe integral lead plus extension cable matches the intended total system length, route the cable away from pinch points and hot surfaces, and seat the connectors fully. Verify the loop after installation by confirming the probe gap voltage at the monitor.

Compatibility

This component belongs to the 3300 XL 8 mm proximity system and is engineered to work with the associated probes, extension cables, Proximitors, and monitoring hardware of the same system. Bently Nevada components sharing the same part number are fully interchangeable, so a stocked spare can be fitted without re-engineering the measurement loop. TenBN can supply the complete chain under consistent part numbers.

Maintenance Advice

Inspect the cable jacket and connectors during outages for cuts, moisture ingress, or loosened couplings, and confirm the run remains clear of abrasive surfaces.

Procurement Advice

Confirm the complete part number against your machine’s bill of materials before ordering, since each option digit changes the mechanical or electrical fit. TenBN stocks genuine Bently Nevada components and provides the official service documentation for this model. For inventory, pricing, and lead time on the 330104-04-10-05-01-CN, contact [email protected].

Frequently Asked Questions

What approvals or certifications does it carry?

Compliance documentation covers country Specific. Confirm the approval suffix on your part number before ordering for hazardous-area use.

Can this spare be interchanged with existing components?

Bently Nevada components sharing the same part number are fully interchangeable, so this spare can replace an existing unit without recalibrating the loop when the complete part number matches.

How do I confirm the right part number?

Check every option digit against the machine bill of materials, then contact [email protected] with the full string; the TenBN team will confirm fit, stock, and documentation.