Bently Nevada 330101-00-61-20-02-CN Extension Cable

Product Introduction

The Bently Nevada 330101-00-61-20-02-CN is an extension cable that supports reliable condition monitoring on rotating machinery. As a genuine Bently Nevada part, it integrates with existing protection loops and is available from TenBN with the official service documentation.

Technical Parameters

• Model: 330101-00-61-20-02-CN
• Product Type: Extension Cable
• Product Series: 330101
• Unthreaded length Option: 00 – 0 mm
• Overall case length Option: 61 – 610 mm
• Total length Option: 20 – 2.0 metre (6.6 feet)
• Connector and cable type Option: 02 – Miniature coaxial ClickLoc, connector, standard cable
• Agency approval Option: CN=Country Specific Approval

Parameter Analysis

Configuration of the 330101-00-61-20-02-CN is carried entirely in its part number, which makes the full string the reference point for spare parts planning and system design. The unthreaded length Option specifies 00 – 0 mm. The overall case length Option specifies 61 – 610 mm. The total length Option specifies 20 – 2.0 metre (6.6 feet). Compliance documentation covers cN=Country Specific Approval.

Because cable, probe, and Proximitor are calibrated as a system, keeping the same part numbers across the loop preserves scale factor accuracy and simplifies replacement during outages.

Application Scenarios

This extension cable connects the proximity probe to its Proximitor on turbines, compressors, pumps, and other rotating equipment, routing the measurement signal from the machine casing to the electronics location while preserving signal integrity over the full system length.

Installation Guide

Plan the run so that probe integral lead plus extension cable matches the intended total system length, route the cable away from pinch points and hot surfaces, and seat the connectors fully. Verify the loop after installation by confirming the probe gap voltage at the monitor.

Compatibility

This component belongs to the 3300 XL 8 mm proximity system and is engineered to work with the associated probes, extension cables, Proximitors, and monitoring hardware of the same system. Bently Nevada components sharing the same part number are fully interchangeable, so a stocked spare can be fitted without re-engineering the measurement loop. TenBN can supply the complete chain under consistent part numbers.

Maintenance Advice

Inspect the cable jacket and connectors during outages for cuts, moisture ingress, or loosened couplings, and confirm the run remains clear of abrasive surfaces.

Procurement Advice

Confirm the complete part number against your machine’s bill of materials before ordering, since each option digit changes the mechanical or electrical fit. TenBN stocks genuine Bently Nevada components and provides the official service documentation for this model. For inventory, pricing, and lead time on the 330101-00-61-20-02-CN, contact [email protected].

Frequently Asked Questions

What approvals or certifications does it carry?

Compliance documentation covers cN=Country Specific Approval. Confirm the approval suffix on your part number before ordering for hazardous-area use.

What connector or interface does it use?

It uses – Miniature coaxial ClickLoc, connector, standard cable, matching the standard Bently Nevada measurement chain.

Can this spare be interchanged with existing components?

Bently Nevada components sharing the same part number are fully interchangeable, so this spare can replace an existing unit without recalibrating the loop when the complete part number matches.

How do I confirm the right part number?

Check every option digit against the machine bill of materials, then contact [email protected] with the full string; the TenBN team will confirm fit, stock, and documentation.